Beaded Place Card Holders

1. Each place card holder requires
a double loop memory wire ring.
Cut your memory wire so that you
have two loops together.

2. Using a needle-nose pliers, turn
one end of the memory wire into a
small closed loop.

3. Bead the double loops of
memory wire and turn in the last
end as in step #2.

4. Cut about 12” of your 20-gauge
wire. Refer to How To Make A
Charm Wrap and wrap the end of
your wire up to step #3 of these
instructions. Hook on your beaded
memory wire to the loop you just
created.

5. Complete the steps in How To
Make A Charm Wrap.

6. Using your rosary tool, start
molding the rest of your wire
gauge into a curvy stand up to 3”
in total length.

7. Anchor the cardholder stand to
the heavy object you’ve selected by
wire wrapping the rest of the wire
around it. Trim any excess wire.
Note: we used a cluster of stones
that we secured together with the
remaining wire.

8. Ready for the table!

Beaded Place Card Holders

20 gauge wire

Assortment of crystals that
fit this wire

Small ring size memory wire

Tools: needlenose pliers,
rosary pliers, heavy duty
wire cutter, heavy object
(cluster of stones, weighted
small gift box) to anchor the
card holder.

Home > Learning Center > P rojects > Beaded Place Card Holders